Days Verb Manuel d'utilisateur télécharger pdf (Page 11)

Days Verb Power Chair

User Manual

- 14 -

Freewheel Operation

To push the Powerchair by hand or in the event of a fault or

battery failure the motors/gear boxes can be released allowing

the Powerchair to be pushed.

The levers should be switched to the freewheel position. On

the gearbox by rotating them through 90°. Use the manual

brakes to park the chair.

CAUTION! - Always re-engage the freewheeling device after

use. Failure to do so may result in injury

Wheels and Tyres

Regularly check the condition of front and rear tyres for wear and tear. Contact

your supplier for replacements. Your Powerchair may have split rim wheels

which are held together by screws or bolts. When these are removed the wheel

rim separates for easy access to carry out puncture repairs or tyre replacements.

Disassembly & Storage

Your Powerchair can be disassembled and folded for storage:

1) Fold the two footrest plates upwards

2) Remove kerb climber unit (if fitted)

3) Disconnect plug and socket between battery boxes and remove rear box

4) Pull to slide front box and disconnect main loom plug and socket. Remove

second battery box

5) Pull the rings of the four release pins holding the battery support basket in

place. Remove basket.

6) Using both hands, grip front and rear of the seat upholstery and pull up to

fold the chair

7) To unfold the chair, place each hand on both seat tubes and push down-

ward firmly. Lock the front and rear release pins to secure battery basket in

place. Slide batteries into position and reconnect

Drive mode

Freewheel mode

- 11 -

Please refer to Shark user guide for full instructions at the end of this user

guide.

1 2 ... 6 7 8 9 10 11 12

Pas de commentaire

Days Verb Manuel d'utilisateur Page 11